3. When using a common coil or a coil whose resistance is above 1.5ohm in TC-Ni/TC-Ti/TC-SS/TCR (M1,M2,M3)
mode by mistake, the device will automatically switch to VW mode.
How to put custom logo in the device?
Download the file on our official website, plug the device in with USB cable, and double click the EleafUpdate.exe.
Then click “LOGO” and open the image you choose to put it in the device. Finally press the fire button twice in quick
succession when the device is powered on to enter logo on/off interface and press up or down button one time to
turn on/off logo.
Note:
1. Please make sure the image you choose is a monochrome image of 96*16 pixel in the format of bmp.
2. If you fail to put the custom logo in and the device shuts down, press the down button one time to restart the
device.
Firmware Upgrading:
The firmware can be upgraded by connecting the device with a computer through the USB
port via a micro USB cable.
Functions of Micro USB Port Charging:
The battery power indicator on the screen of iPower will keep flashing when the remaining power of the device is
less than 10%.
The device can be charged through USB port at the bottom of the device via 1A wall adapter or a computer. It will
take about 6.5 hours to get a full charge via 1A wall adapter.
Properties
Atomizer Protection:
Each time when vaping time exceeds ten seconds, the output shuts off automatically with
“Over 10s” display on the screen.
Atomizer Short-circuit & No Atomizer Protection:
When atomizer short-circuit occurs, the OLED screen will
display “Atomizer Short”. The screen will display “No Atomizer” when there is no atomizer connected.
Low-voltage Protection:
When the voltage of the device is below 3.3V, the OLED screen will display “Lock” and the
output will cut off automatically. Charge the device to reactivate it.
Temperature Protection:
In TC-Ni/TC-Ti/TC-SS/TCR(M1,M2,M3) mode, when the actual temperature of coil
reaches the set temperature, the screen will display "Temp Protection".
Temperature Alert:
If the temperature of device is over alert temperature, the output will shut off automatically
and the screen will display “Device Too Hot”. You can continue to vape after it cools down.
Precautions
1. Only have your iPower repaired by Eleaf. Do not attempt to repair the unit by yourself as damage or personal
injury may occur.
2. Do not leave the iPower in high temperatures or damp conditions, otherwise it may be damaged. The appropriate
operation temperature is within 0
℃
to 45
℃
while charging and -10
℃
to 60
℃
while using.
3. Do not attempt to combine the iPower with parts from other brands of e-cigarettes. If it is damaged in this way,
our company will not take on responsibility and your warranty will be void.
Warnings
1. Please keep out of reach of children.
2. This device is not recommended for use by young people or non-smokers.
Please read the full instruction manual which was provided with this product.
