Introduction and Setup Page 7
USB Port:
a. Connect the included USB cable from
the tester to your PC.
b. Plug the included wrist strap into the
probe socket.
c. Plug the included Power cord (latch
side up) into the tester.
d. Connect the power cord to the power
supply.
e. Plug the loose end of the power supply
into the same grounded outlet that your
computer is plugged into.
Step 3
Connect one end of the ribbon cable to
the bottom connector on the CR tester
(bump side up).
Step 4
Connect the other end of the ribbon cable
to the transition board connector on the
harness board.
Step 5
The drop nail bracket is located at the center
of the demo harness board. Pinch and raise
the drop nail bracket to raise the drop nails
as shown.
Step 6
Skip
to “Starting the Software” on page 10.
Bottom
Connector
Transition Board
Connector
Wrist Strap
USB Cable
Power Cord
Power Cord
Power Supply
Drop Nails
Drop Nail
Bracket
Power Supply
