Circutor Wallbox eNext M-C1, Installation Manual

Page: 16 / 32

Wallbox eNext
Installation guide 16
5
Material:
Tap drill 6/8M
Tools:
• Allen wrench of 2,5 mm is included in the installation kit.
• Screws, sealing washers and plastic anchors are
not included
.
• The fastening system of the Charge Point has been designed to be
installed on a wall.
» This system has been tested on a concrete wall, to be securely fixed in
such conditions is recommended to use:
3 x Inox A2 wall screws: DIN 7982 Ø4,8x3
3 x plastic anchors: 6x40 or 8x40
» If the wall surface has different properties, the screws and plastic
anchors must be defined by a qualified installer.
Screw driver Driller Ratchet
(3)
2.5mm Allen
(3) Ratchet tool can be used to open/close the charge point if the conditions of the installation
requiers it