Page no.
3
1.3.-
Safety advice.
For safety reasons it is essential that anyone installing or handling the
QNA-412
follows the usual safety procedures as well as the specific
warnings in this instruction manual.
If the equipment is used in a way not specified by the manufacturer,
the equipment's protection may be compromised.
When it is likely that a loss of protection has occurred (for example visible
damage) the equipment must be disconnected from the supply. In this event contact
a qualified service representative.
1.4.-
Operating instructions.
The
QNA-412
is programmable, measuring instrument offering a series of
options that may be selected using the set up menus.
Before installing the equipment and taking measurements carefully read
sections
INSTALLATION, START-UP
and
SETTING
for the
QNA-412 analyzer.
Select the most suitable way of obtaining the required data.
It must be remembered that once the equipment is connected, the
terminals may be dangerous when touched and opening the covers or
removing pieces may access parts that are dangerous when touched. The
equipment must not be used until it is fully installed.
2.-
GENERAL FEATURES.
The QNA-412 quality analyzer is specially designed equipment to control
electrical supply according to the IEC 61000-4-30 standard.
•
Harmonics measurement according to IEC 61000-4-7.
•
Flicker measurement according to IEC 61000-4-15.
•
Measurement of the main electrical parameters.
−
Voltage, current, power, PF....
−
Voltage and Current harmonic distortion...
−
Neutral Current and Neutral-Earth Voltage
•
4 quadrant measurement (Consumption and generation).
•
Flicker measurement according to IEC 61000-4-15.
•
High degree of protection under severe electrical conditions:
−
With a broad supply voltage and measurement margin.
−
High degree of overvoltage and transient protection.
•
Option to connect to 3 and 4 wire systems.
•
With a broad supply voltage margin: 63 – 520 V AC.
•
Internal battery. The equipment can continue recording in the absence of
power supply voltage.
•
4 Mbyte internal memory where all parameters measured by the QNA-412
are stored.
•
GSM / RS-232 / RS-485 communication. (According to model).
•
Assembled in self-extinguishing casing in sizes and with fixing points in
accordance with the DIN 43857 standard.
