Circutor P26121, Instruction Manual

Page: 17 / 30

4�- START-UP
Once the unit is installed you must carry out the following start-up sequence for it to work prop-
erly.
4.1.- AUTOMATIC MODE
If the unit is going to operate in automatic mode, see Section “ 5.2.- AUTOMATIC ” . The start-up
sequence is:
1�- Put the mode selector switch in Manual Mode (OFF).
2�- Lift the RCCB cover.
3�- Put the RCCB contact in ON mode.
4�-
Lower the RCCB cover.
5�- Put the mode selector switch in Automatic Mode (ON).
Note : The switch has an M2 hole where you can attach a seal or a padlock to block access to
the RCCB and any other attempts at manual reclosing (
Figure 10
).
Figure 10: Switch's M2 hole to seal access to the RCCB�
4.2.- MANUAL MODE
If the unit is going to operate in manual mode, see Section “ 5.1.- MANUAL ” . The start-up se-
quence is:
1�- Put the mode selector switch in Manual Mode (OFF).
2�- Lift the RCCB cover.
3�- Put the RCCB contact in OFF mode.
4�-
Lower the RCCB cover (optional).
17
Instruction Manual
REC 3 - REC 3C