Circutor line-EDS-PS, Instruction Manual

Page: 11 / 30

3�5�2�- INSTALLATION
Before installing a new device, it must be disconnected from all power supplies.
The correct steps to connect the devices are:
1�- Using a flat head screwdriver, remove the expansion connector’s protective covers located on the
side of the devices, (
Figure 8
).
Figure 8: Installation step 1�
2�- Insert the expansion connector and fastening clips into one of the devices (
Figure 9
).
Figure 9: Installation step 2�
3�- Connect both devices and fasten them by pushing the front clips down (
Figure 10
).
11
Instruction Manual
line-EDS-PSxxx