– 4 –
Capacitance:
4n-40n-400n-4
µ
-400
µ
F
±
(5% + 10),
±
(8% + 10) (above 100
µ
F)
(Test voltage: 3V / Test frequency: 4n-40nF 1KHz; 400n-4
µ
F
70Hz; 400
µ
F 7Hz)
Frequency:
4K-40K-400K-4000KHz
±
(0.5% + 1)
(Autoranging) (Sensitivity: 0.2Vrms minimum)
Inductance:
4m-40m-400m-40H
±
(5% + 10)
4H
±
(5% + 20)
(Test frequency: 4m-40mH 1KHz; 400mH-4H 70Hz; 40H 7Hz)
Transistor HFE: 0-999 HFE
Test base current: 10
µ
A / Test voltage: 3.0
±
0.4V
Diode :
Test current: 1.0
±
0.6mA / Test voltage: <3.5V
Logic:
Logic High 2.8V
±
0.8V / Logic Low 0.8V
±
0.5V
Frequency Response: 20MHz
Detectable Pulse Width: 25nS
Indication: 40msec beep at logic low
Overload Protection
Voltage:
500VDC / 350VAC - 400mV ranges
1000VDC / 750 VAC - 4-40-400-1000/750V ranges
Current:
0.5A / 250 V Fuse for 40m-400mA ranges
10A / 600 V Fuse for 10A range (Maximum 60 seconds)
Resistance:
500VDC / 500VAC
Capacitance:
3VDC / 3VAC rms
Frequency:
500VDC / 500VAC rms
Inductance:
3VDC / 3VAC rms
Logic:
500VDC / 500VAC rms
Diode Test:
500VDC / 500VAC rms
MEASUREMENTS
Please take a few minutes to read the instructions and warnings prior to use.
1 DC VOLTAGE MEASUREMENT
!
WARNING: Maximum input is 1000V DC.
1-1
Plug the red test lead into the V
Ω
jack and the black test lead into the
COM jack.
1-2
Set the DC/AC switch so that
DC
is displayed on the LCD.
1-3
Set the range switch to the desired
V
voltage setting. If you are unsure of
the voltage being measured, select the highest range and reduce until a
satisfactory reading is obtained.
