4
Figure 1 – Definition of Model Designators of 3E Series Pumps
E. ORDERING INSTRUCTIONS
All correspondence pertaining to renewal parts for equipment must refer to instruction manual number and
should be addressed to nearest Imo representative. Handling of renewal orders will be greatly facilitated if
following directions are carefully observed:
1. Provide number of instruction manual with revision level and date.
2. Provide serial number of pump for which part is desired. This number appears on pump nameplate.
3. Identify kit (Minor or Major) required.
Imo sales and service representatives are listed herein and in General Installation, Maintenance and
Trouble Shooting Manual, SRM00046.
F. OPERATION
F.1 LIQUID LIMITATIONS
CAUTION
ATTENTION
Never operate with thin liquids such as solvents or water. Pump is designed for liquids having
general characteristics of oil.
F.2 OPERATING LIMITS
CAUTION
ATTENTION
Operating conditions, such as speed, fluid viscosity, temperature inlet pressure, discharge
pressure, filtration, duty cycle, drive type, mounting, etc., are interrelated. Due to these variable
conditions, specific application limits may be different from operational limitations. Equipment
must not be operated without verifying system’s operating requirements are within pump’s
capabilities.
