CIP UNIGAS HP60 Series, Manual Of Installation - Use - Maintenance

Page: 41 / 52

C.I.B. UNIGAS - M039150CF
4 1
WIRING DIAGRAMS
Complete key
AGQx.1A27 Auxiliary device for UV probe
BP Light oil pump contactor coil
BV Fan motor contactor coil
CM Operation selector 0) Off - 1) Gas - 2) Light oil
CMF Manual operation selector 0) Stop - 1) High flame - 2) Low flame - 3) Automatic
CP Contacts on pump motor contactor
CR1 Contacts on auxiliary relais
CTP Contacts on pump motor thermal cutout
CTV Contacts on fan motor thermal cutout
CV Contacts on fan motor contactor
EV1 Gas solenoid valve, network side (or valves group)
EV2 Gas solenoid valve, burner side (or valves group)
EVG1 Light oil solenoid valve 1st stage
EVG2 Light oil solenoid valve 2nd stageF÷F4Fuses
FC UV probe
IM Fan motor switch
IL Auxiliary line switch
L Phase
LAF High flame operation signaling lamp
LB Burner lockout signalling lamp
LBF Low flame operation signaling lamp
LEV1 EV1’s opening signaling lamp
LEV2 EV2’s opening signaling lamp
LEVG1 EVG1’s opening signaling lamp
LEVG2 EVG2’s opening signaling lamp
LGB/LMG/LME22.33 SIEMENS control box
LPG Low gas pressure in the network signaling lamp
LS Burner in stop position (STAND-BY) signaling lamp
LSPG Gas valves leakage signaling lamp
LT Intervention of thermal cutout signaling lamp
LTA Ignition transformer in operation signaling lamp
MA Burner power supply terminal board
MC Burner components terminal board
MP Pump motor
MV Fan motor
N Neutral
PA Air pressure switch
PGMAX Maximum gas pressure switch (optional, if provided remove the connection between terminals 156 e 158 in terminal
board MC)
PGMIN Minimum gas pressure switch
PS Reset pushbutton for LGB/LMG/LME
Pt100 Connection for Pt100
R1 Auxiliary relay
SQN72/STA Actuator for air damper,
ST Series of thermostats or pressure switches
TA Ignition transformer
TP Pump motor thermal cutout
TV Fan motor thermal cutout
VPS504 DUNGS Leakage control device (optional, if provided remove the connection between 177 and 178 on terminal board MC)
ATTENTION:
1 - Electrical supply 400V 50Hz 3 N a.c.
2 - Don’t reverse phase with neutral
3 - Ensure to the burner a proper hearthing
Wiring diagram Cod. 05-573.
Electrical wiring diagram Cod. 18-119
-
Burners provided with printed circuit