3
Install Your FuzzyScan
Adjust Reading Angle
The readability may be impacted by the specular reflection caused by the
perpendicular reading angle. To get the most optimal reading performance,
you are suggested to install the FM400 at an approximate
15°
angle to the
perpendicular line of the target barcode. However, the reading angle and
distance may vary depending on the size and printing quality of barcodes.
Mount Your FuzzyScan
There are two
M3
mounting holes on the bottom of the chassis. Please follow
below procedures to mount your scanner.
Prepare two appropriate M3 screws (minimal 4mm in depth) and decide
your desired mounting location. Then adjust the two screws to
accommodate
27mm
center width.
Optimize the mounting position by adjusting the reading angle and
distance. Ensure the illumination envelop is not blocked by any external
object.
Use the test mode to verify the actual reading rate. If the reading rate is
not good enough, please adjust the reading angle and distance to get the
optimum readability.
Front-view
Side-view
