Cineversum Black Wing MK 2015 R599850, User Manual

Page: 29 / 44

CINEMASCOPE SETUPS
R599850 - BW MK2015 User Manual 29
14.2 Cinemascope setup with Lens Zoom
Select “Menu => Installation => Lens Memory 1”
Zoom in, until the left and right borders of the picture fits the 2.35:1 screen borders. Save the lens position in the
lens memory 1. You can also edit the memory 1 name to “Cinemascope”.
Select “Menu => Installation => Lens memory 2”
Make sure to project a 16:9 picture, zoom out until the picture top and bottom fit the top and bottom of the screen.
Adjust the focus and offset if required, then save this position into the memory 2. You can additionally edit the
memory name to “Standard”.
Switch format using the Remote Control Unit.
You can now switch between Cinemascope and standard formats easily by using the [Lens Mem]ory button on
the RCU and selecting the correct lens memory according to the source format.
Because of the nature of the lens motorization, the precision overtime is not enough to perpetually
maintain the correct zoom / focus / position after several zoom in and out. It is required to periodically
alter the lens setting.
14.3 Installing a 2.35:1 screen with the Cine-Twist anamorphic kit
Plug the 12V Trigger output of the projector to the Anamorphic motorization
12V Trigger
to anamorphic
motorization
Connect the lens motorization to the 12V Trigger output.
Configure the function “Menu => Function => Trigger => On (Anamo)”
The “Function => Trigger” menu determines the 12V Trigger output located in the panel input at the rear of this
unit. This is a global parameter (for all inputs. Set the 12V Trigger to “On (Anamo)“ mode so that it is most of the
time Off and switches On when the picture is in Cinemascope format and Anamorphic mode A is selected. The
picture is then vertically stretched and the lens is needed.
• Set 12V Trigger to: “Function => Trigger => On (Anamo)”.
Video source is 16:9: set [Anamo]rphic to Off
When you select a 16:9 input choose the anamorphic OFF to obtain move the anamorphic lens out. Menu
“Installation => Anamorphic => Off”
Video source is Cinemascope: set [Anamo]rphic to Mode A
Select Anamorphic mode A for this input in the menu Input “Installation => Anamorphic => Mode A”.