3 | Cineak - Luxury Seating
Fortuny inclienr - installation & operating manual - 10/2009
2
Installation
B.
Once the backrest is installed, securely engaged and screwed
to the seat base, attach the white elastics on the backrest flap to
the bottom of the seat frame (upside down silver posts).
C.
Carefully lower the chair back onto the floor. Continue steps
A - C with all remaining chairs in the row.
ROW INSTALLATION
All chairs are connected to one another by lifting one chair/
armrest onto the locking bar attached to the next chair. When
connecting seats to armrests, connect the control wires from the
armrest to the corresponding driver box underneath each chair.
E.
Lift each piece so it fits into the receiving lip
(8)
connected to
the other chair/arm. You may need to adjust the armrest forward/
backward until it lowers properly into position. Continue until
all chairs of row are connected.
POWER CONNECTIONS
Find the power cables, and plug into driver/control box located
at the rear of each chair frame. Connect other end of this cable
into the power supply/transformer and connect the power sup-
ply to the wall outlet. When connecting the transformer, ensure
the cable coming from the driver box under the chair is installed
into the transformer before connecting to the wall outlet.
TRANSFORMER PLACEMENT
Place transformers behind chair/row so there is proper
ventilation and they are clear of all moving parts. Do not place
transformers inside armrest cavity or underneath/chair.
We highly suggest that once the chairs are assembled, you look
underneath footrests from front to make sure all wires are run
properly so the chair nor any parts are sitting on top of any wires
and not rubbing/dragging on any moving parts. Take location of
wires into consideration if the row/seating needs to be moved.
CINEAK does not advise using surge protectors, extension cords
or splitters. CINEAK will not be responsible for damage or
hazard caused by improper placement of transformers or wires.
2.1
Installation Instructions
Installation is recommended to be performed by 2 people and
is done by attaching armrests/seating pieces to adjacent seat
pieces - lifting each chair/arm onto the one beside it - no bolts!
ROW CONFIGURATION (see prev. page)
Start by placing all parts (seating/armrests) of each row next to
one another in the room so the numbers on the parts correspond
to the drawing in the Packing/Installation Reference (prev. page).
BACKREST INSTALLATION
The backrests will need to be installed first, and it is suggested
that all backrests are attached prior to connecting any chairs in
row(s). If lumbar support has been ordered, see section 4 now.
A.
Tilt the seat piece forward onto its armrests so you are able
to kneel behind it
(1)
. While someone holds the backrest up
in place
(2)
, lift the finish flap/piece on the backrest up
(3)
and
notice the securing wooden block and female “C” brackets on
each side
(4)
. Align the two female “C” brackets on each side
of the backrest
(4)
to the corresponding male mounts on the
seat frame
(5)
.
Once aligned, guide the backrest onto the male brackets on the
seat frame and push on the backrest until it touches the leather
of the seat. Make sure the backrest is pushed down completely
and the male/female connection is properly secured.
1
2
3
4
5
8