2
LOCATION OF THE GRILL
This grill is designed and certified for OUTDOOR USE in well ventilated area only.
The installation of this appliance must conform with the local codes, in the absence of local
codes, with the current National Fuel Gas Code, ANSI Z223.1 in the US or CAN/CGA-B149.2
Propane Installation Code, in Canada.
Observe the following safety rules before each use:
DO NOT install in or on recreational vehicles and/or boats.
DO NOT use inside a building, porch, balcony, garage or any other enclosed or semi-
enclosed area.
Maintain at least 36 inches (915mm) from all sides of the grill to any combustible material.
DO NOT locate under an unprotected combustible ceiling or cover.
DO NOT store anything under the grill. Keep area around and under the grill clear of any
combustible material, gasoline and other flammable liquids and gases, including spare LP
cylinder.
DO NOT place grill on an uneven or unlevelled surface.
Locate grill out of traffic`s way. Place the grill in a place where people are not likely to
bump into or tip it over.
DO NOT use grill if hose is damaged. Replace with a hose assembly as specified by the
manufacturer, see `HOSE`.
FOLDING AND UNFOLDING OF THE GRILL
To unfold the grill:
Place the grill on the ground and lift the grill up by a wooden handle. Push the legs down
and swing them away from the grill.
Unfold the outer legs through a complete 360 degrees circle and place them into the two
metal hooks at the end of the grill. Push the leg assembly firmly into place.
Read the section `LP Cylinder` on Page 3 of these instructions before connecting.
To fold the grill:
Turn the LP tank gas valve completely clockwise to close the supply to the grill.
Disconnect the gas connection to the LP tank.
Remove the LP tank and put it aside.
Lift the grill by the wooden handles and unhook the leg assembly from one end of the grill.
Fold the outer legs through a complete 360 degree circle under the grill, pushing the leg
assembly firmly into place.
CAUTION:
DO NOT attempt to fold the grill while it is hot. Let it cool before folding.
