Operation Manual
NORM-O-TEMP, Model 111W
Page 9 of 26
NORM-O-TEMP
®
System Operating Instructions “Quick Start” Guide
Read Operation Manual before using this device
First Time Use Cleaning:
Refer to Section 4-2 for cleaning instructions.
Initial Operation:
1. Fill reservoir with distilled water
2. Insert power cord plug into hospital grade outlet
3. Connect hyperthermia blanket or pad
4. Turn power switch “ON”
Unit will go through an 8-10 second calibration cycle to test all indicators and will flash the set point
temperature of 37
°
C. Observe Water Flow Indicator on the side of the unit to verify that the pump is
circulating water when blanket/pad is connected. The unit will start heating to a preset temperature
of 37
°
C. To change the desired set point temperature, proceed to step 5 below.
5. Depress the “TEMP SET” button. The display will flash the previous set point temperature or the
default temperature of 37
°
C if the unit has been turned OFF, and then back ON. NOTE: You have
five seconds to depress one of the arrows or the temperature readout will return to the actual
reservoir water temperature.
6. Depress the “UP”
▲
or “DOWN”
▼
arrow to raise or lower the set point temperature to the desired
setting.
Summary of Contents for NORM-O-TEMP
Page 27: ......
