CIMLINE Magma 410, Owner'S/Operator'S Manual

Page: 6 / 52

6
Controls and Their Functions
NOTE: This general outline will only familiarize you with the machine. Read through the
entire manual before putting this machine into operation.
1) Tank Outlet Valve: Allows melted material from the tank to flow into the pumping
system.
2) Access Port: The sealing wand is placed in here when not in use. This allows op-
erator to continue circulating material through the hose to prevent material from cooling
and freezing up.
3) Loading Doors: Place the material on safety door to load the melting tank.
4) Micropanel ignition Switch: Use the key to turn the engine on and off.
5) Wand Holder: On models with the electrically heated hose, the wand is placed into
this holder.
6) Material Temperature Gauge: Reads material temperature as it pumps through
plumbing system.
7) Pressure Valve: This valve controls the flow rate of the material being pumped to
the hose and sealing wand by changing the pressure setting. (Turning the valve clock-
wise will increase the pressure which in turn will increase the flow). During sealing oper-
ations, this valve alone can be used to regulate flow.
8) Sealing Hose Valve: Opening this valve will allow the material being pumped to
flow through the hose and sealing wand. The valve should be in the full "on" position dur-
ing operation to prevent flow restriction.
9) Control Panel: The main control panel is used to control the direction of the mate-
rial pump and agitator, and you can also monitor the temperature of the material and
heat transfer oil.
10) Pressure Gauge: This gauge measures the pressure required to turn the agitator.
By observing this gauge, the operator can tell if the agitator is rotating.
11) Cabinet Temperature Gauge: Indicates the temperature inside the cabinet. Do not
exceed 320º F (160º C).
12) Thermal Regulating Gate: Lift lever to open gate which will direct hot air to cabi-
net to heat pump and plumbing.