10
K300 Optima Rev.07.99
E*
C
B
A
D
Install Card Output Hopper onto printer
by hooking over bottom edge of card
exit aperture.
Open Cover, and adjust lever to
correct position. Repeat for different
card thickness. (Factory setting is for
30mil (0.762mm) card thickness. See
diagram below:
B - CARD THICKNESS CONTROL LEVER
This item is operated by the user to
prevent more than one card feeding
into the printer at the same time and
C - CARD OUTPUT HOPPER
For collecting printed cards
Card Thickness:
A - 60mil (1.524mm) to 50mil (1.27mm)
B - 40mil (1.016mm)
C - 30mil (0.762mm)
D - 20mil (0.508mm)
E*- Less than 20mil (0.508)
* Start at lowest position and move lever
up to match card thickness.
For other card thickness, start lever at
lowest position and move up until cards
feed.
Summary of Contents for K300 Optima
