Mist blower M1200US
Page 31
T
ROUBLE SHOOTING
The engine doesn’t start
Cause
Solution
1.
The switch (Picture 10 position 2) is on
“0”.
Move it to “position “1”
2.
Damaged ground cables or lack of
contact
Replace it or insulate it
3. Absence of fuel.
Refuel
4. Defective valve in the fuel cap
Clean or replace it
5. Clogged fuel filter in the carburettor
Clean or replace it.
Contact a
‘SERVICE CENTRE’
6. Flooded engine
See the instructions at page 22
7. Clogged fuel filter in the tank
Clean or replace it.
Contact a
‘SERVICE CENTRE’
8. Dirty spark plug
See chapter
“spark plug”
9. Carburettor suction not working
See points 3, 4, 5.
Contact a ‘SERVICE CENTRE’
10.
Current doesn’t reach the spark plug
Ignition coil broken or not regulated.
Contac
t a ‘SERVICE CENTRE’
11. Dirty carburettor air filter
See chapter
The RPM is not regular, engine stops
Cause
Solution
See points 4, 6, 7
12. Spark plug not firmly tightened.
Tighten it using the proper spanner
13.
Damaged ground cables or lack of
contact
Replace or insulate it
14. Defective ignition coil
Replace it.
Contact a
‘SERVICE CENTRE’
Engine does not reach max. revolution
Cause
Solution
See points 5, 6, 7, 9
15. The air filter is dirty
Clean it; s
ee chapter ”Air filter”
16.
Exhaust hole clogged by combustion
deposits.
Clean or replace it.
Contact a ‘SERVICE CENTRE’
17. Air infiltrations through gaskets.
Check screw tightening and gaskets
condition
18. Worn oil-proof rings on the crankshaft.
Replace it.
Contact a ‘SERVICE CENTRE’
19. Insufficient compression of the cylinder
Contact a ‘SERVICE CENTRE’