Rear Panel Controls and Connectivity:
Screw terminal connections for Power, Wired Input, Loudspeaker Outputs and Line Level outputs are
located on the rear PCB of the AVID3.
Power is provided via the included PSU; its cable being marked with a white line on the positive (+) core
which connects to the V+ terminal, the plain black core is negative (-) which connects to the G terminal.
The Wired Input terminal on the rear is configured for a Stereo Input Signal; the three-way connector has
terminals for L (Left Signal), G (Screen) and R (Right Signal).
Important Information:
It is important to note that if using the audio input loacated on the rear of the AVID3 that the signal
applied is at full line level.
When using this application an appropriate screened cable is required to reduce the possibility of external
signal interference.
Note.
The Wired Input Terminal is in parallel with the 3.5mm Jack Input on the front panel; if both inputs
are connected and a signal is present on both, then the two sources will be mixed together (This should
be clearly explained to the user).
A jumper is provided to allow the AVID3 to be used in either mono or stereo mode, the factory default is
stereo. If set to mono the amplifier will provide a mixed output to each loudspeaker terminal.
Loudspeakers should be wired to the L+ L- and R+ R- terminals, ensuring the phase of each loudspeaker
is the same.
The line output is stereo and provides a fixed line output signal for feeding and external source such a s a
slave amplifier or induction loop system.
If you are experiencing any problems please contact your reseller or the CIE-Group Technical Support
Department on +44 (0)115 9770075.
Wired
Line Input
Connector
Power Supply Input
Connectors
Loudspeaker Output
Connectors
Loudspeaker Balance
Trim Pots
L+ L- R- R+
OUTPUT
A
UDIO
INPUT
V+ G
Stereo
Jumper
Line Output
Connectors
