D936/D937 - 900MHz Cordless
USING THE D936/D937
13
B
ASE
R
INGER
a.
Press the
or
VOLUME
key on the base
while the phone is not in use.
b.
The base will ring. Press the
or
VOLUME
key to
decrease or increase the ringer volume until the
desired ring level is obtained. There are nine
different levels of ring (including off).
S
PEAKER
a.
Press the base
SPEAKER
key.
b.
Press the
or
VOLUME
key
on the base while the
phone is in use to increase or decrease the
speaker/intercom volume. There are eight volume
levels.
T
IMING
C
ALLS
When you are on a call, a call timer is shown. The timer
displays the duration of the call. When the timer goes past
99 minutes and 59 seconds, it starts over at 0:00.
T
EMPORARY
T
ONE
S
ERVICE
If your phone is set to Pulse and you need Tone service for
interacting with bank or
other automated services, you can
temporarily change your dial setting to Tone. Press
*
during
the call and the phone switches to temporary Tone service
for the duration of the call. The phone returns to Pulse
service when you hang up. See “Selecting a Dialing Method”
on page 10.
L
OCATING
A
L
OST
H
ANDSET
Should you misplace your handset, you can locate it quickly
and easily by pressing the
PAGE / FIND
key on the base. The
handset beeps for 15 seconds, or until you either:
■
Press the
PAGE / FIND
key again
or
■
Press any key on the handset except
TALK / END
. (If
you press
TALK / END
, you enter intercom mode.)
If the handset does not beep, it is either out of range, or the
battery needs recharging.
L
OW
B
ATTERY
When the handset battery charge becomes low, you will
hear three beeps and will see the display message
RECHARGE BATTERY
. You have approximately 5 minutes to
conclude your call or switch phones before your call is
dropped.
NEED TO KNOW
Prior to first use, place the handset in the cradle and
charge the battery for at least 12 hours. The handset
charge light on the base comes on to tell you that the
handset is charging.
D936-937.book Page 13 Friday, August 30, 2002 10:24 AM
