D936/D937 - 900MHz Cordless
4
INSTALLING THE D936/D937
T
O
M
OUNT
ON
A
W
ALL
a. Place the
wedge over the
lower portion of
the base so the
arrow points
away from the
phone. Install the
wedge by aligning
it over the holes
and pressing
down and in the
opposite
direction of the
arrow until it
snaps into place.
b. Plug the short line
cord into the
phone jack
marked TEL LINE.
c. Thread the phone cord through the open channel in
the base.
d. Plug the other end of the phone cord into the wall
phone jack.
e. Use the gap on the underside of the base to gather
any excess cord.
f. Hang the base over the installation hooks (wall plate
not supplied).
R
EMOVING
THE
D
ESKTOP
/ W
ALL
M
OUNT
W
EDGE
Remove the mounting wedge from the bottom of the base
by placing your thumb at the top of the arrow on the
mounting wedge and pressing down in the direction of the
arrow.
A
TTACH
THE
B
ELT
C
LIP
The belt clip allows you to hang the handset from your belt.
Place the belt clip on the back of the handset. Align the tabs
on the belt clip with the slots on the handset. Press the belt
clip to the handset to snap the tabs into the slots. Make sure
both tabs are securely snapped into the handset slots.
To remove the belt clip, pull one of the side tabs out of the
slots in the handset. Carefully pull the clip away from the
handset.
NEED TO KNOW
The belt clip can remain on the handset when the
handset is placed in the base.
A
TTACH
H
EADSET
(O
PTIONAL
)
A headset with a standard 2.5 mm plug may be used in the
headset jack located on the side of the handset. Keep the
headset jack cap in place when the headset is not in use.
Wall Mounting
D936-937.book Page 4 Friday, August 30, 2002 10:24 AM
