3
Congratulations on your purchase
!
By purchasing the
CICLOMASTER CM 8.3A
you have acquired an electronic multifunctional sports
computer with an integrated altimeter function, with the highest level of precision and newest digital
transmission technology . The
CM 8.3A
has a state of-the-art electronics, is waterproof and convinces
through his high durability .
It’s special feature: Transmission from transmitter to device is implemented on a digital communication
level and this makes it extremely faultresistant . The
CM 8.3A
has a Two-in-One system . This means that
you can use it with 2 bikes and have the recorded values displayed separately for either bike or as a total .
In this case, the
CM 8.3A
automatically identifies immediately, after the first wheel rotations, which of
the two bikes is being used .
As another special features the
CM 8.3A
has an optional cadence measurement and an optional heart
rate measurement (for this you need separately available accessories ) .
In order to use all functions of the
CM 8.3A
in the correct way, please read through this operating manual
carefully .
Content:
- CICLOMASTER CM 8.3A
- battery type CR 2032
- battery cap
- handlebar bracket
- speed-transmitter
- cable ties for mounting
- spoke magnet
1. General information
CM 8.3A
has three modes: Bike 1, Bike 2, and Non-Bike mode .
To switch from one mode to another, simultaneously press the right and left buttons briefly (switching
is only possible if speed SPD = 0) . In the Non-Bike mode, only bicycle independent functions will be
displayed .
CM 8.3A
has an
automatic energy save mod
e: If bike 1 or 2 does not receive any signals for more
than 5 minutes and you don’t press any button during this time, the display will be switched off (in the
non-bike mode it will be turned off after 15 hours .)
By pressing any button the display will be switched on again .
Because of the new digital transmission technique, the transmitters have to be initialized before using
CM 8.3A
for the first time . We recommend initializing the transmitters before mounting the
CM 8.3A
on
the bike .
2. Installation
The handlebar bracket can be mounted on the handlebar or on the stem .
Picture A:
Mounting is possible on handlebar (Position A-1) or stem (Position A-2) .
Picture B:
For using it on the stem (Position B), rotate upper part .
Remove the protective tape .
Place the handle bar and fasten it with the cable ties .
Picture C:
Mount the transmitter with cable ties on the fork an cutt the ends
Picture D:
Fix the magnet on a spoke so that it will face the mark on the transmitter . Adjust the magnet
position and fine tune the sensor if necessary (distance between transmitter and magnet max .
3 mm) .
Picture E:
Rotate the CM 8 .3A to 45 degree left and install it into the bracket . Then rotate it 45 degrees
right to lock it . To unlock, rotate 45 degrees to the left .
A-1
A
B
90
ϒ
D
C
E
45
ϒ
KLICK!
F
A-2
