Ciarko 5902429921032, Manual, Page: 29 / 76

29
OPERATION
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker
hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and
for another 15 minutes approximately after terminating cooking.
MAINTENANCE
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical
supply by switching off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed
from the socket.
CLEANING
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out
maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid
detergent. Do not use abrasive products.
DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and
replacement of the filters may cause fire risks. Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to
inappropriate maintenance or failure to observe the above safety recommendations.
GREASE FILTER
Traps cooking grease particles. The grease filter must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour slightly, but this does not a¨ect its filtering
capacity. To remove the grease filter, press it and pull it down.
Brightness adjustment
Use this function to adjust brightness. When lighting is on touch and hold „ 5 ” for about 2 second to adjust
brightness. Lighting brightness will be reduced. Touch „ 5 ” again to reduce brightness another level down.
When the lowest brightness level is reached, touch „ 5 ” again to cycle to maximum brightness. Repeating this a
number of times will allow you to chose the desired brightness.
Control Panel
It is equipped with a touch controls. Touch one the sensors to enable the desired function:
1 - Reduce fan speed
2 - Increase fan speed
3 - Speed display The hood fan can run at 4 speeds (4 speed is boost function )
4 - Off timer
5 - Lighting on/off The lighting operates independently of hood fan
Off Timer
Use off timer to turn off the hood after a specified time. Use off timer to filter the fumes out of the air after
cooking. Maximum delay time is 90 minutes. Touch „
4 ” to cancel the off-timer at any time. The number „ 0. ”will
flash on the display. Then use „ 1 ” and „ 2 ” to select the delay in the range 1–9 (multiply the number by ten to
obtain delay in minutes, 1 – 10 minutes, 2 – 20 minutes ... 5 – 50 minutes). Touch „ 4 ” again to activate the
function. The off timer is set a dot will flash on by the digit on the display. Touch „ 4 ” to cancel the off timer.
Touch „ 1 ” to reduce the delay time down to zero. Touch „ 4 ” to confirm the off-timer has been cancelled.
Cancelling the off-timer does not turn off the lighting.
1 2 3 4 5