CONTENT OF THE CARTON ECO300KS/ECO400KS
(1) Motor
(2) Gate fixing bracket
(3) Key
(4) Fixing Systems
(5) Condenser
(6) Manual
(7) Clevis pin and rings
1
PLEASE STA RT B Y READING THESE IMPORTANT SAFETY RULES
SAVE
THESE INSTRUCTIONS
Installation and wiring must be in compliance with
your local building and electrical installation codes.
Power cables must only be connected to a properly
earthed supply.
Any entrapment possibility by the moving wing
between wing & walls must be secured with safety
edges or IR-sensors.
Disconnect electric power to the system before
making repairs or removing covers.
A disconnecting device must be provided in the
permanently-wired installation to guarantee all-pole
disconnection by means of a switch (at least 3mm
contact gap) or by a separate fuse.
When using tools and small parts to install or carry
out repair work on a gate exercise caution and do
not wear rings, watches or loose clothing.
Make sure that people who install, maintain or
operate the gate drive follow these instructions.
Keep
these instructions in a safe place so that you can
refer to them quickly when you need to.
Please remove any locks fitted to the gate in order to
prevent damage to the gate.
It is important to make sure that the gate always
runs smoothly. Gates which stick or jam must be
repaired immediately.
Employ a qualified technician
to repair the gate, never attempt to repair it yourself.
This safety alert symbol means "Caution" - failure to comply with such an instruction involves risk of personal injury or
damage to property. Please read these warnings carefully.
This gate drive mechanism is designed and tested to offer appropriately safe service provided it is installed and operated
in strict accordance with the following safety rules.
Incorrect installation and/or failure to comply with the following instructions may result in serious personal injury or
property damage.
Keep additional accessories away from children. Do
not allow children to play with pushbuttons or remote
controls. A gate can cause serious injuries as it
closes.
After the installation a final test of the full function of
the system and the full function of the safety
devices must be done.
The full protection against potential squeeze or
entrapment must work direct when the drive arms are
installed.
This drive cannot be used with a gate incorporating
a wicket door unless the drive cannot be operated
with the wicket door open.
1
