13
Zone Mode
Arm Zone
Sensors set to Arm Zone are armed when the system is in Away (Full Arm) or Home Arm
(Part Arm) status. We recommend setting window/door sensors to this zone as they
usually secure the perimeter of the house.
Home Zone
Sensors set to Home Zone are only armed when the system is in Away (Full Arm) status.
During Home Arm mode, these sensors will not be armed and will not activate the alarm
when triggered. We recommend setting PIR motion sensors to this zone as they usually
secure the interior of the house.
24-Hour Zone
Sensors set to 24-Hour Zone will activate the alarm when triggered, regardless of the
alarm status at the time (away or disarmed).
Delay Zone
The working mode of sensor in this zone will be same as Arm Zone sensor’s, but the Hub
will alarm after an Entry Delay Time
*
if this sensor is triggered when system was armed or
in home mode.
*
Entry Delay Time: you can set this delay time on LTE-400[Settings]-[Delay Settings]-[Entry Delay].
Note:
Optional Smoke, Gas Leakage or Water Flood Sensors are automatically registered as 24-
Hour Zone sensors and cannot be changed to other Zones. Any motion or door/window sensors
paired to the hub by the tamper switch will be registered as an 24-Hour sensor.
