Chrysler 300 C 2009, Owner'S Manual, Page: 80 / 676

78 GETTING TO KNOW YOUR INSTRUMENT PANEL
Diagnostics
This feature allows the driver to view engine and
emission vehicle faults.

Push OK to have the most recent fault code
sent.

There is a delay when the next diagnostic
code is requested during which the following
message is displayed:
“Checking System for Diagnostic Codes.”

Driver must push the OK button again to see
the next P code otherwise current message
remains displayed.

Driver exits when they cycle to another
submenu (up or down).

Faults are displayed from newest to the
oldest.

If the menu is exited before the end of codes
is reached - when the driver re-enters the list
will be restarted from the beginning.

When no codes are present or the last code
is reached = (P0000) and this message is
displayed:
“No or End of Diagnostic Codes.”
Speed Warning
Push and release the up or down arrow
button until the Speed Warning Menu icon/title
is displayed in the instrument cluster display.
Push and release OK to enter speed warning.
Use the up or down arrow button to select
a desired speed, then push and release OK to
set the speed. The white passive speed limiter
telltale will light up with a notification message
(Speed Warning Set to XX, followed by the
selected unit). When the set speed is just
exceeded, an audible chime will sound for up to
10 seconds or until the speed is no longer
exceeded. The white passive speed limiter tell -
tale will turn yellow and will flash, and a pop up
message of “Speed Warning Exceeded” will
display.
NOTE:
You can turn the Speed Warning off by using the
up or down arrows to scroll through speed list
and select OFF at the bottom of the list.
Battery Saver On/Battery Saver Mode
Message — Electrical Load Reduction
Actions — If Equipped
This vehicle is equipped with an Intelligent
Battery Sensor (IBS) to perform additional moni -
toring of the electrical system and status of the
vehicle battery.
In cases when the IBS detects charging system
failure, or the vehicle battery conditions are
deteriorating, electrical load reduction actions
will take place to extend the driving time and
distance of the vehicle. This is done by reducing
power to or turning off non-essential electrical
loads.
Load reduction is only active when the engine is
running. It will display a message if there is a
risk of battery depletion to the point where the
vehicle may stall due to lack of electrical supply,
or will not restart after the current drive cycle.
When load reduction is activated, the message
“Battery Saver On” or “Battery Saver Mode” will
appear in the instrument cluster.
These messages indicate the vehicle battery
has a low state of charge and continues to lose
electrical charge at a rate that the charging
system cannot sustain.
NOTE:

The charging system is independent from
load reduction. The charging system
performs a diagnostic on the charging
system continuously.
20_LX_OM_ENA_GCC_t.book Page 78