Chrysler 300 C 2009, Owner'S Manual, Page: 32 / 676

30 GETTING TO KNOW YOUR VEHICLE
for LO. Turning the heating elements off will
return the user to the radio screen.

Press the heated seat button once to turn
the HI setting on.

Press the heated seat button a second
time to turn the LO setting on.

Press the heated seat button a third time
to turn the heating elements off.
If the HI-level setting is selected, the system will
automatically switch to LO-level after approxi -
mately 60 minutes of continuous operation. At
that time, the display will change from HI to LO,
indicating the change. The LO-level setting will
turn off automatically after approximately
45 minutes.
NOTE:

Once a heat setting is selected, heat will be
felt within two to five minutes.

The engine must be running for the heated
seats to operate.
Vehicles Equipped With Remote Start
On models that are equipped with remote start,
the heated seats can be programmed to come
on during a remote start.
This feature can be programmed through the
Uconnect system. Refer to “Uconnect Settings”
in “Multimedia” for further information.
Rear Heated Seats — If Equipped
On some models, the two rear outboard seats
may be equipped with heated seats. There are
two heated seat switches that allow the rear
passengers to operate the seats independently.
The heated seat switches for each heater are
located on the rear of the center console.
You can choose from HI, LO, or OFF heat
settings. Amber indicator lights in each switch
indicate the level of heat in use. Two indicator
lights will illuminate for HI, one for LO and none
for OFF.

Push the heated seat button once to turn
the HI setting on.

Push the heated seat button a second
time to turn the LO setting on.

Push the heated seat button a third time
to turn the heating elements off.
When the HI-level setting is selected, the heater
will provide a boosted heat level during the first
four minutes of operation. Then, the heat
output will drop to the normal HI-level. If the
HI-level setting is selected, the system will auto -
matically switch to LO-level after approximately
60 minutes of continuous operation. At that
time, the number of indicator lights changes
WARNING!

Persons who are unable to feel pain to the
skin because of advanced age, chronic
illness, diabetes, spinal cord injury, medica -
tion, exhaustion or other physical condition
must exercise care when using the seat
heater. It may cause burns even at low
temperatures, especially if used for long
periods of time.

Do not place anything on the seat or seat -
back that insulates against heat, such as a
blanket or cushion. This may cause the seat
heater to overheat. Sitting in a seat that has
been overheated could cause serious
burns due to the increased surface
temperature of the seat.
20_LX_OM_ENA_GCC_t.book Page 30