Chroma 63200A Series, Operation & Programming Manual

Page: 33 / 141

High Power Electronic Load 63200A Series Operation & Programming Manual
3-2
Table 3-1 Front Panel Description
Item Name Description Refer to
1 Power switch The AC power switch of Electronic Load.
2 VFD The display shows the setting information. 3.2.1
3 HOTKEY The shortcut keys for switching loading modes. 3.2.2
4 FUNCTION keys There are A/B, RANGE, MODE, EXTEND, LOCK,
Config/Local, EDIT, SPEC, Short, Recall, Adva,
Save and Clear keys. 3.2.3
5 Entry keys The numeric keys and ENTER key.
6 Arrow keys These two keys are used to change the setting
page and select the desired form. They are also
used to move the cursor to the desired position
when editing parameters. 3.2.4
7 Push Button Rotary Press down the push button rotary to enter into the
parameter setting page. When the settings are
done, press the push button rotary again to confirm
the setting. 3.2.4
8 USB HOST USB HOST (not fully support yet).
VFD 3.2.1
The loading mode is displayed as below:
1. Parameter setting lines: The setting parameters of each mode.
2. Reading display: It displays the measured voltage (V) & current (I) & power (W).
3. Status line: It shows the mode, range, Load ON, Short ON and Von status.
4. Up & down scroll: When a down arrow appears, it means there are parameters in the
next page for setting.
5. HOTKEY: The shortcut for entering the mapped loading mode.
HOTKEY
There are 4 HOTKEYS that can switch the loading mode rapidly. When in a loading mode
(such as basic or Advance mode), simply press a HOTKEY can switch to the mode indicated.