17
English
Maintenance and adjusting
1. Lubrication for the running belt:
In order to keep the machine in the best condition, please add
some Silicone oil between the running belt and the running board
after 50 hours or 1 to 2 month of use. But the running belt may
slip, if you lubricate too much. To lubricate the belt please pull
the walking belt up and injection the silicone oil into the gap
between belt and walking deck.
2. Adjusting running belt:
You need to adjust the walking belt to the normal position, per
the following steps if it is off.
1. Set speed at 3-5km.
2. Using the Allen key to adjust the belt tension bolt on the end
cap of the system frame.
3. If you want to move the belt towards left, turn the right tension
bolt clockwise.
4. If you want to move the belt towards right, turn the left tension
bolt clockwise.
5. If you have already done according to the steps above and
it is still not at the good range, then the running belt should be
damaged already, please contact your local dealer for replace-
ment.
3. Running belt slips:
1. Make sure the walking belt is not too loose.
2. Make sure the motor belt is not too loose.
4. Abnormal noise from the machine
1. Check if any screw of machine is loose.
2. Check if the motor belt is off.
3. Check if the running belt is off.
How to start:
1. Plug in the AC cable into wall power (230V~50Hz) and switch on
the main switch (17) which is located in front of the main frame.
2. Stand on the black area of side rails (25).
3. Put the safety key (48) onto the computer (46) and the computer
will show normal manual mode. Put the safety clip (48) at your
exercising cloth. Press Start-Button and after a Countdown the
treadmill start moving. Start walking onto the walk surface (30)
when speed is slowly and follow the speed. Familiarize yourself
with the machine at a low speed settings.
3. Run in the middle of the running surface (30), hold yourself tight
at handrail (41) if you feel insecure and don’t step on the side rails
(25). Only run with look at the Computer (46) on the treadmill duri-
ng the running. In emergency case, step of the treadmill lateral and
hold onto the handle (41).
Function of safety key
The safety clip (48) has an emergency function. In fear or danger
or if you fall down or jumped from it, the safety clip (48) will lose
position at computer (46) and stops the motor with break system.
Put the safety key (48) out from computer on any status, the dis-
play is shows. “ - - - “. Put the safety key on computer, then the
display will enter normal manual mode. All parameter reset to zero.
Summary of Contents for TM 1 Go
Page 3: ...3 ...
