14
Assembly instructions
Remove all the separate parts from the packaging, lay them on thefloor and
check that all are there on the basis of the packing list in these instructions for
assembly and use. Please note that a number of parts have been connected
directly to the main frame and preassembled. In addition, there are several
other individual parts that have been attached to separate units. This will
make it easier and quicker for you to assemble the equipment.
Step 1:
Attach the stabilizer (22) + (32) at main frame (21).
1.
Attach the front foot (22) with the preassembled transport rollers (23)
to the main frame. Do this with the two screws (33), washers (18), spring
washers (24) and cap nuts (30).
2.
Attach the rear foot (32) to the main frame. Do this with the two screws
(33), washers (18), spring washers (24) and cap nuts (30). After assembly
has been completed, you can compensate for minor irregularities in the floor
by turning the eccentric cap (34). The equipment should be set up that the
equipment does not move of its own accord during a training session.
Step 2:
Attach the pedal (26) at pedal crank (36).
1.
Screw the right pedal (26R) into the locator in the right-hand side (as
seen in operation) for the pedal crank (36R) (warning! the screw direction
is clockwise).
2.
Screw the left pedal (26L) into the locator in the left-hand side (as seen
in operation) for the pedal crank (36L)
(Warning! the screw direction is anti-clockwise).
3.
Then mount the pedal straps left and right on the associated pedals (26).
(The pedals are signed with „L“ for Left and „R“ for Right.)
Step 3:
Attach the front post (12) at main frame (21).
1.
Hold the handlebar support (12) with the computer cable (15) Against the
main frame holder. Connect the plug for the computer cable (15) coming
out of the bottom of the handlebar support (12) of the computer with the
matching plug for the sensor cable (55) coming out of the main frame
(21).
(Note: The computer cable harness (15) projecting from the support (12) must
not slide into the tube, as it is required for later steps of installation.)
2.
Connect the middle section tension cable (56) to the bracket of lower
section cable tension (16) (See figure [1]-[3]). Before this step of the
installation, it is advisable to adjust the resistance setting to the highest
stage, at which the cable extends furthest from the sheath. Put the lowest
part of cable (16) into the small hook (figure 1). Pull it (figure 2)until the small
hook get in higher position and than insert the cable (16) onto the bracket
(56) (figure 3).
3.
Place the handlebar support (12) in the locator provided for it in the
main frame (21). Ensure that the cable connections made in step 3 are not
squashed. When putting the steering tube in place, push the former slowly
down into the locator in the main frame. Screw the handlebar support (12)
onto the base frame (21) with the screws (17), spring washers (24) and
washers (18).
Summary of Contents for 99062
Page 3: ...3 Deutsch ...
Page 43: ...43 Русский ...