Service Manual
Page 12
•
The entire driveshaft will push through the
support bearings located in the headtube.
•
To remove the rear driveshaft, pull it forward
through the support bearings by gripping the
universal joint section.
•
The rear drive pinion will slide out from the
dropout slot.
Installation:
•
Slide the rear and front drive-shafts into their
respective frame tubes. The front shaft will
slide through the headtube support bearings
and then firmly seat on the edge of the miter
gear. The rear shaft will slide through the sup-
port bearings but may not seat completely on
the u-joint section. There may be a small gap
between the u-joint and the bearing the top
yoke.
•
If necessary, replace the rubber u-joint boots.
•
Slide the square spline section into the round
female section before you begin to re-attach
the suspension link and the shock.
AWD Frame Drive-System Maintenance
