Christie VC-RAD 14 Select, User Manual

Page: 6 / 15

4
3. TOOL SYSTEM
3.1 Tool Handle:-
The VC-RAD Select is activated with a Trigger Switch. The Forward/Reverse Switch controls the
direction of rotation. The 4-digit LED display shows the Target Torque and the various user menus. The
keypad is used to set the desired torque and change tool settings.
Upon receiving the VC-RAD Select tool, please check the following:-
1. Check the shipping package condition and report any damage to the carrier that delivered your
package.
2. Remove the VC-RAD Select and accessories from the shipping package and ensure that you have
all the components listed above.
3. Do not use the VC-RAD Select Tool System if the power cord is cut, frayed, or is of the wrong
type, or external damage has been done to the gearbox or tool handle.
3.1.1 Trigger Lock:-
The Trigger Lock is useful when transporting or storing the VC-RAD Select. The Trigger Lock blocks the
Trigger Switch, disabling the tool. Enable the Trigger Lock while the VC-RAD is not in use.
To enable the Trigger Lock:
•
Slide the Forward/Reverse Switch to the centre position so that the Trigger Switch cannot be
pressed.
To disable the Trigger Lock:
•
Slide the Forward/Reverse Switch to the forward or the reverse position. The Trigger Switch can
be pressed.
3.2 LED Display Interface:-
The VC-RAD Select user interface consists of an
LED display and three-button keypad (See Right).
The LED display uses four digits to display torque
values and the various menus. Use the up and down
buttons are used to modify numbers and navigate
menus. Use the centre button to enter the Main
Menu and set options.
3.3 Power On:-
Before powering on the VC-RAD Select:
1. Ensure that the power cord and tool voltage are correct. Do not attempt to use an incompatible
power source with the VC-RAD Select (see Electrical Specifications Section on page 1).
2. Ensure all loose clothing is kept away from the VC-RAD Select Tool.
3. Keep the gearbox, reaction arm, and motor components away from yourself when plugging in the
VC-RAD Select.
Turn on the VC-RAD Select by plugging the power cable into the appropriate outlet. The LED display
will show the Target Torque once the unit has powered on. The VC-RAD Select will be ready to operate
when the torque display is shown. To change the Target Torque and access other user functions, (see
Section 4 - Interface and Settings)
LED Display
Up Button Down
Button
Centre
Button