10
Reaction Arm Height
Ensure that the height of the socket is even with the
height of the Reaction Arm
CORRECT:
The Reaction Arm and socket are even.
The height of the socket cannot be shorter
or longer than the height of the Reaction
Arm.
INCORRECT:
The leg of the
Reaction Arm is too short in
the left image and too long in
the right image.
Reaction Arm Foot
Ensure that the foot of the Reaction Arm aligns with the
reaction point.
CORRECT:
The foot of the Reaction Arm aligns with the
reaction point.
The length of the foot cannot be shorter or longer than the reaction point.
INCORRECT
: The
reaction point is too
close in the left
image and too far in
the right image. Do not react
against the heel of the reaction
arm.
5.2 Torque Operation:-
To operate the tool in a torque cycle:-
1.
Ensure the tool is in Torque mode (for example see right).
2.
Ensure the LED Display is showing the correct units (see Section 4.2.1
– Change the Torque Units).
3.
Change the torque value as desired (see Section 4.1 – Changing
Torque). Allow the display to flash after changing the torque,
indicating that the torque value is saved and set.
4.
The VC-RAD Select is ready to torque at the displayed setting. Place
the VC-RAD on the joint system. Ensure the Forward/Reverse Switch
is in the Forward position.
5.
Press and hold the On/Off Trigger. (To stop the Torque Cycle at any time, release the On/Off
Trigger.)
6.
When the VC-RAD reaches the selected Torque, the tool will stop turning. Release the On/Off
Trigger.
Summary of Contents for VC-RAD 14 Select
Page 15: ...13...
