Section 1: Introduction
Solaria One/Solaria One
+
Service Manual
1-3
020-101039-02 Rev. 1 (06-2013)
1.1.5
UV Light
UV HAZARD! Never look directly into the lens or into an open projector. The extreme
light output could cause permanent eye damage.
Wear ultraviolet-blocking eye wear with
side-guards if servicing with the lamp ON. Failure to comply results in death or serious injury.
The projector lamp is an intense source of light and heat. One component of the lamp light is ultraviolet (UV)
light, which can produce the same effect on the skin and eyes as sunlight. Avoid exposure to UV radiation by
keeping the lamp fully enclosed when you operate the projector and by wearing authorized protective clothing
(598900-95) before opening the lamp door. DO NOT operate the lamp without the lamp door in place.
NOTES:
1)
The American Conference of Governmental Industrial Hygienists (ACGIH) recommends that
occupational UV exposure for an 8-hour day be less than 0.1 microwatts per square centimeters of effective
UV radiation. An evaluation of your workplace is advised to Make sure that employees are not exposed to
cumulative radiation levels exceeding the government guidelines for your area.
2)
Be aware that some
medications are known to increase sensitivity to UV radiation.
This projector must be operated in an environment that meets the operating range specifications.
1.1.6
High Temperature
Only Christie authorized service technicians trained specifically on lamp
replacement and lamp safety may handle the lamp. A high-pressure lamp may explode if
improperly handled. Always wear Christie approved protective safety clothing (598900-95)
whenever the lamp door is open or while handling the lamp. Never attempt to access the
lamp while it is running. Wait at least 15 minutes after turning the lamp off before turning the
projector off, disconnecting it from AC, and opening the lamp door. Failure to comply results
in death or serious injury.
The projector lamp operates at very high temperatures and pressures. If you do not let the bulb cool sufficiently
prior to handling, the lamp could explode and cause personal injury or property damage. After powering the
lamp off, you must wait at least 15 minutes before disconnecting AC and opening the lamp door. This practice
provides enough time for the internal lamp cooling fans to cool the bulb. Always cool the bulb completely
before handling. Always wear Christie-approved protective safety gear (598900-095) before opening the lamp
door.
1.1.7
Power Cord
Do not operate the projector if the AC supply is not within the specified
voltage and power range. Power rating information for the projector is provided on the
license label on the back of the projector. Always power down the projector before
unplugging the AC power cord. Wait 15 minutes for the main exhaust fan to turn off and for
the lamp to cool sufficiently before unplugging the projector. Failure to comply could result in
death or serious injury.
Use only the power cord provided with the projector. DO NOT compromise safety by using other connectors.
Summary of Contents for Solaria One
