Securing the projector to the stacking frame
Secure the projector to the stacking frame before stacking additional projectors.
Danger! If not avoided, the following results in death or serious injury.
•
TIP HAZARD! Stacked frames must be secured together using all locking pins.
•
Use all mounting points, including the safety point, when installing the product overhead.
Warning! If not avoided, the following could result in death or serious injury.
•
A minimum of four people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
•
The supporting structure must safely support the combined load of the product, all attached
hardware, and components following all local safety standards and regulations.
1. Turn off the projector.
Allow the cooling fans to stop before proceeding with step 2.
2. Disconnect the projector from AC power.
3. Remove lens from projector, if installed.
4. Verify the base plate of the frame is in a flat position and is level.
5. Adjust the feet of the projector.
•
For HS Series, Q Series, and GS Series, adjust the feet of the projector so there is no
extension.
•
For H Series, extend the projector feet out 4 mm before placing in the frame.
The projector must sit flat on the base plate.
6. Place the four spacers provided with the frame over the four appropriate mounting holes on
top of the base/mounting plate.
•
For HS Series, place the four spacer provided with the frame over the four HS Series
mounting holes on top of the base plate.
•
For GS Series 630/635, DWU6322-GS, and DWU7062-GS only, place the four spacers
provided with the frame over the four orange GS Series mounting holes on top of the
mounting plate.
Ensure the holes on the base plate and spacers are aligned.
7. Lift the projector onto the base plate through the top opening of the frame.
Ensure the lens mount faces the front of the frame, as indicated below.
Assembling the Christie One rigging frame
Assembling the Christie One Frame Instruction Sheet
3
020-101901-04 Rev. 1 (03-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
