Monitoring and Maintenance
Mirage M Series User Manual
115
020-101942-02 Rev. 1 (10-2018)
Notifying users after a set number of hours of lamp use
When
Lamp
>
Warn when lamp reaches (hours)
is set, the projector presents a warning
message when the lamp has a recorded on time that exceeds the specified number of hours. The
warning is displayed on the status page for each lamp, where applicable. A value of 0 turns this
feature off.
This setting is user-defined only. It has no bearing on lamp warranty and is not tied to actual lamp
life in any way.
Replacing the lamps
1. Turn off the lamps using the remote keypad or the built-in keypad with the lamp
OFF
command
(see Step 5) or by opening the lamp door.
The lamps turns off automatically when the lamp door is open.
2. To access the lamp compartment, use a #2
Phillips® screwdriver to turn the one
captive screw on the lamp door counter-
clockwise.
3. Wait at least 10 minutes before handling
the lamps, to allow the lamps to cool.
4. Remove the old lamp.
a. Loosen the three captive screws
securing the lamp using a #1 Phillips® screwdriver.
b. Carefully remove the lamp from the projector. Place the old lamp in a location where it
cannot fall or be bumped.
5. To use lamp OFF command:
a. In the lamp menu, select
Change Lamp
.
This prompts for the old lamp serial number (if it was not previously entered).
b. Enter the new lamp serial number.
While this action is not mandatory, Christie recommends it for accurate lamp statistics to be
archived.
6. Install the new lamp:
a. Take precaution to align the new lamp properly in the correct orientation inside the
projector.
b. Press firmly to seat the lamps, ensuring the lamp is secure.
Warning!
Failure to comply with the following could result in death or serious injury.
• Never attempt to access the lamp while the lamp is ON. After turning the lamp OFF, it is crucial
that you wait at least 10 minutes before handling the lamp. This provides sufficient time for the
lamp cooling fans to properly cool the lamp.
• Handle lamps with extreme caution. Dispose of lamps according to safety regulations for your
area.
http://www.pureglare.com.au