25
LWU420 User Manual-Operating Guide
020-000262-01 Rev. 1 (06-2010)
Operating
Main
Sub
RGB1
RGB2
HDMI
Component
Scart RGB
S-V
ideo
S-V
ideo
RGB1
0
0
0
0
0
0
RGB2
0
0
0
0
0
0
HDMI
0
0
0
X
X
X
Component
0
0
0
0
0
Scart RGB
0
0
X
X
X
S-Video
0
0
X
0
X
X
Video
0
0
X
0
X
X
PbyP (Picture by Picture)
The
PbyP
is a function to display two different picture signals on a screen that is
split in two areas for each signal. Some of functions can be used with the same
operation as it for the normal mode (not in the
PbyP
mode). There are some
operations available only in the
PbyP
mode.
The setting information will be appeared for several
seconds when the
PbyP
function is started. It shows
the input signal information for each area. Also, there
will be a yellow frame and speaker mark with one of the area that is the main area
where most of operations are effective. The information can be appeared using
the cursor buttons ▲/▼/◄/► when the setting information is not on the screen.
Press the PbyP button on the remote control, then
the
PbyP
function will be started. To quit the
PbyP
mode, press the button again.
Most of operations are effective for the main area
only. Also the audio input signal paired with the
picture input signal for the main area is assigned as
the audio output signal. The main area can be changed using the
cursor buttons ◄/► when the setting information is on the screen.
Press the INPUT, RGB or VIDEO button while in
the
PbyP
mode, the menu to select the input signal
will be appeared. Choose a signal using the cursor
buttons ▲/▼. If you want to change the signal in the sub
area, switch the main area using the cursor buttons ◄/► first.
Displaying the same signal on the both areas is not allowed.
For other combinations of the input signal, refer to the right
table. Any combinations marked with X can not be selected.
<signal combination>
Press the MY BUTTON1/2 assigned the
PbyP SWAP
(
49
). The position of the both area is exchanged
without any setting change.
Starting the PbyP
Changing the main area
Showing the setting information
Changing the picture input signal
Using the PbyP SWAP function
normal mode
PbyP
mode
setting information
•For some signals, it may not be displayed correctly in the
PbyP
mode,
even if it can be displayed properly in the normal mode.
NOTE
main area
sub area
main area
