LW650 Lamp/Filter Replacement Instruction Sheet
1 of 3
020-000185-01 Rev. 1 (03-2009)
LW650 Lamp/Filter Replacement
Instruction Sheet
INTRODUCTION
These instructions outline the details for Lamp and Filter replacement in the LW650 projector (Model
No. 121-002103-01).
NOTICE:
Use only a Christie approved Lamp and Filter Kit for your specific
projector model.
KITS REQUIRED
003-120483-01 (Replacement Lamp)
003-002722-01 (Replacement Air Filter)
INSTRUCTIONS
LAMP REPLACEMENT
When the projected image darkens or color reproduction becomes poor, the lamp needs to be replaced.
NOTE:
If the projector is ceiling mounted, or if the lamp bulb has broken, the lamp unit should also be
replaced.
Always power down and disconnect/disengage all power sources to the
projector before servicing or cleaning.
Allow the projector to cool for at least 45 minutes before the lamp cover is
opened. The inside of the projector can become very hot and may cause injury.
Do Not operate the projector while any of the lamps are removed. This may
result in malfunctions, fire hazard, or other possible accidents.
NOTICES: 1)
Switch the lamp OFF before opening the lamp cover.
2)
For continued safety, replace
with a lamp assembly of the same type.
3)
Do not drop the lamp assembly or touch a glass bulb! The
glass can shatter and may cause injury.
