Installation safety and warning guidelines
Read all safety and warning guidelines before installing the projector.
Warning! If not avoided, the following could result in death or serious injury.
•
Possible hazardous optical radiation emitted from this product. (Risk group 3)
•
Christie products must be installed and serviced by Christie qualified technicians.
•
Do not operate the product without all of its covers in place.
•
A minimum of four people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
•
Always install safety straps when the frame and projector are installed overhead.
•
Observe load ratings and applicable local safety codes.
•
When installing the projector in portrait mode, the rigging device must have a sufficient load
rating, as identified in this manual.
•
Do not stack more than two projectors in landscape orientation.
•
This product must be installed within a restricted access location not accessible by the general
public.
•
Install the product so users and the audience cannot enter the restricted area at eye level.
•
Only personnel who are trained on the precautions for the restricted access location can be
granted entry to the area.
•
Only Christie qualified technicians are permitted to open product enclosures.
•
Prior to rigging the projector, inspect the quarter-turn fasteners on the covers to ensure they are
safely secured.
•
Prior to rigging the projector, always tighten the lock nut on the projector feet against the
bottom of the projector to lock the feet. Otherwise, the feet must be removed.
Caution! If not avoided, the following could result in minor or moderate injury.
•
ELECTRICAL and BURN HAZARD! Use caution when accessing internal components.
•
Only Christie qualified technicians are authorized to use the tools provided in the toolbox.
AC power precautions
Read all safety and warning guidelines before connecting to AC power.
Warning! If not avoided, the following could result in death or serious injury.
•
SHOCK HAZARD! Only use the AC power cord provided with the product or recommended by
Christie.
•
FIRE AND SHOCK HAZARD! Do not attempt operation unless the power cord, power socket, and
power plug meet the appropriate local rating standards.
•
SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
•
SHOCK HAZARD! The AC power cord must be inserted into an outlet with grounding.
•
SHOCK HAZARD! Disconnect the product from AC before installing, moving, servicing, cleaning,
removing components, or opening any enclosure.
•
Install the product near an easily accessible AC receptacle.
Introduction
Christie Griffyn Series Installation and Setup Guide
8
020-103314-08 Rev. 1 (06-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
