2 of 4
Use of Entero Mounting Plate Instruction Sheet
020-100406-02 Rev. 1 (09-2010)
To change the mounting plate position:
1. Remove the four screws that secure the plate to the adjuster.
2. Align the holes on the mounting plate (Figure 2) with the four holes on the adjuster (Figure 3):
• For rear access, align the holes marked R.
• For front access, align the holes marked F.
Figure 2 Mounting holes
Figure 3 6-Axis adjuster
3. Secure with 4 mounting screws (012-100164-02).
4. Insert the guide pins on the inside of the mounting plate flange in the corresponding holes marked
F or R (Figure 4) and secure with the provided washers and screws (012-100266-02).
Figure 4 Mounting plate flange - rear access pin holes
NOTE:
See the CC50/CC67/CC72 Installation Manual (P/N: 020-100248-02) for information about
installing the adjuster and mounting plate in the cube and installing the projector.
Front Access (F)
Rear Access (R)
Rear Access (R)
Front Access (F)
