2. Connect the A, B, and PE harness connectors to the corresponding terminals.
Do not use the H1, H2, or H3 terminals.
3. Tighten the screws at each terminal.
4. Re-attach the signal terminal cover using the two cover screws. To avoid pinching the cable,
ensure the cable and rubber grommet are placed inside the cover cutout.
5. Connect the RS-232 connector to a serial cable and into the RS-232 communication port on
the projector.
Installing and setting up
C RGB PLF Installation and Setup Guide–CP4450-RGB
31
020-103072-02 Rev. 1 (09-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.
