Installation Procedures
Matrix StIM™ WQ/SIM WQ User Manual
7
020-100883-01 Rev. 2 (06-2013)
Mount the Projector
Mounting points are available on all 4 sides of the
projector, including the front face. Each side has 6
mounting points, 2 of which are on the front plate.
The front plate has an additional 7 front facing
mounting points. Christie recommends that a
minimum of 4 mounting points are used in any
installation, with at least 1 of the mounting points
being on the front plate. A 10mm thread engagement
and a minimum torque of 30 in.-lbs (3.5 Nm) /
maximum torque of 35 in.-lbs (4 Nm) is
recommended. For some installations it may be
necessary to remove the front handles once the
projector is in its final location. To remove the handles
use a 5 mm hex driver to loosen the 2 socket head
cap screws.
Mount a Ruggedized Kit (optional)
If you are mounting a ruggedized kit use the 7 designated mounting
points on the front of the projector. The handles will need to be
removed to access 4 of these points. Christie does not provide the
ruggedized kit or the hardware to secure a ruggedized kit. Christie
recommends using M6 hardware with a 10 mm thread engagement, and
a maximum torque of 4 Nm.
Do not stack units. Failure to comply could result in minor or moderate injury.
Failure to comply with the following may result in equipment damage:
• Air flows in through the front of the projector and out the rear of the projector.
Insufficient airflow can cause the projector to overheat during operation and / or place
stress on the source connections. When mounting the projector allow for up to 1100
CFM of airflow through the projector. Ambient temperature must stay below 40° C
(95° F).
• Inlet air temperature must be below 40° C (95° F).
• Keep the projector away from all devices radiating electromagnetic energy. For
example, motors and transformers, speakers, power amplifiers, and elevators.
i
The mounting support system and the mounting surface must be evaluated and
accepted by local authorities and must adhere to local standards and safety regulations.
front plate
mounting point
front plate
mounting point
Summary of Contents for 130-002103-01
