Christie 1000W J Series, Setup Manual

Page: 33 / 58

J Series 1000W & 1200W Setup Guide 4-1
020-100740-02 Rev. 1 (03-2014)
4 Maintenance
Installers, service trained operators and all other users must maintain a safe operating
environment at all times. Read through this section in its entirety and understand all warnings and
precautions before attempting to operate this projector. Refer to
Section 1.2 Safety Warnings and
Guidelines .
4.1 Projector Location
Operate the projector in an environment that meets the operating range specifications in Section
Section 6 Specifications . Do not operate the projector close to water, such as near a swimming pool.
Do not place the projector on an unstable cart, stand or table. If the projector is going to be ceiling
mounted, only use the Christie approved ceiling mount fixture designed for your projector.
A projector and cart combination should be used with care. Sudden stops, excessive force, and uneven
surfaces may cause the projector and cart combination to overturn.
4.1.1 Lamp and Filter Replacement
Lamp
Do not operate the lamp for more than the warranty limit; risk of the lamp shattering increases as a
result of changes in the quartz glass that occur with use. Operation beyond the lamp warranty limit also
significantly reduces brightness output.
Wait approximately 5 minutes after powering down the projector to allow the
lamp to cool sufficiently before removing.
Never attempt to remove the lamp housing directly after use. The lamp is under
great pressure when hot and may explode, causing personal injury and/or
property damage.
Use only lamps supplied by Christie.
Lamp Replacement Procedure
Choose the correct wattage lamp supplied by Christie. Refer to Table 4.1. Read
the lamp replacement procedure in its entirety before proceeding.
A Christie accredited service technician must perform lamp replacement.
Cool the lamp completely and handle by the housing only.
Do not touch the glass window of the lamp. Fingerprints left on the surface can
lead to an intense accumulation of heat called a “hotspot,” which could
potentially result in lamp failure. It is recommended you wear a face shield
when working with the lamp.
For this procedure you will need the appropriate Lamp and Filter Kit manufactured by Christie Digital
Systems. See Table 4.1 .
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING