Touch-it CE
Operating Instructions
Christ Elektronik GmbH
21
/
37
www.christ-elektronik.de
Tel.: +49 8331 8371-0
3.6
Windows CE 6.0/ EC 7 Bootloader & Image Update
The Windows CE 6.0 operating system is located in one single image file with
.bin
extension.
The Windows EC 7 operating system is located in one single image file with .nb0 extension. This
file is located inside the
flash
memory of the Touch-it CE.
This image file is loaded into RAM memory each time the Touch-it CE is powered up. Since the
*.bin / *.nb0
image file is not modified during the use of the Touch-it CE, Windows CE will al-
ways boot from the same clean image.
The only way to update the operating system is to replace the existing
*.bin / *.nb0
file with a
new one. This can be done via LAN, USB, SD, memory or by a terminal connection through
COM1.
3.6.1
Image Update via external memory (USB, SD)
From Christ-Elektronik you can get the files, to make an image update. Below you find the steps
for the update.
-
Unzip all the directories (AutoRun, Autoxsc, etc.) and copy to a USB Stick or microSD card
-
Turn on device and close all running applications
-
Plug in the storage medium (SD, USB) to the device, update is done automatically
-
Wait until the Touch-it CE restarts (about 2-3 minutes)
-
When the message appear: “remove the USB Stick and restart”
-
Turn off the Touch-it Panel PC and remove USB Stick / microSD card afterwards
-
Switch the Touch-it Panel PC on and make a Touchscreen calibration (See chapter Touch Cal-
ibration)
-
Save the Registry (See chapter Software ->Registry)
