WEIGH-MATIC® Scale System
WEIGH-MATIC® Scales Installation
MF1291C
11
Two Scales are available
5000 Pound
[2268 kg]
Scale
8000 Pound
[3629 kg]
Scale
If larger quantities of feed are desired, divide the total feed requirements into two or more equal feedings.
Scale Assembly Installation
5. Refer to
Figure 9
for the layout of the Stand Assemblies and Lever Assemblies.
Figure 9. Installing the Stand Assemblies and Lever Assemblies
1. Place the four Lower Main Stands and the Transverse Stand over the holes drilled in the foundation. See
Figure 10
for correct placement. Install the Anchor Bolts and Safety Chain Assemblies but do not tighten the
anchors until the scale levers are in position.
2. Check all Scale Pivots and Bearings, including those on the weighbeam. They must be CLEAN AND FREE
OF PAINT OR DIRT.
Figure 10. Placing the stands over the drilled holes and bolting in place
1291-18 6/01
Right Main Lever Assembly
Left Main Lever Assembly
Upper Main Stand Assembly
Lower Main Stand
Bearing
Fulcrum
Transverse Stand Assmebly
Load Loop Shackle
Shackle
Transverse Lever Assembly
Steelyard Rod
Trip Loop
1291-14 6/01
Transfer Stand
Lower Main Stand
Remove paint from all
pivots and knife edges