Chord Electronics
ULTIMA 2 |
Manual
_
Chord Electronics
ULTIMA 2 |
Manual
_
10 // 30
11 // 30
Dismantling & radio
frequency interference
1.3
Connecting your equipment
1.4
1.1
Introduction
1.2 Protection against
liquids & heat
1.1
Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
There are no user-serviceable
components within the
ULTIMA 2 or its power
supply. Dangerous voltages/currents
exist within the ULTIMA 2 and its
power supply, posing a severe risk of
electrocution and/or fire.
Never attempt to open,
dismantle or apply internal
third-party devices to it or
insert anything other than the
listed interconnects or speaker cables
within this user manual.
If the ULTIMA 2 develops a fault or
the casework becomes damaged,
immediately disconnect from the
mains power supply and connected
equipment and contact Chord
Electronics for further advice.
Before connecting the ULTIMA 2 to any
equipment, consult the manufacturer’s
user guide to confirm compatibility.
When connecting the ULTIMA 2 to any
equipment, make sure that all devices
are o
ff
, including the ULTIMA 2. Once
connected, switch all equipment on
starting with the source and ending
with the amplification. Initially, operate
the ULTIMA 2 with your preamp/device
on its lowest gain setting and lowest
volume setting, gently increasing to
a comfortable listening level. Never
operate the ULTIMA 2 at excessive
sound levels; permanent hearing
damage and loss can occur.
ULTIMA 2 is supplied with its own
grounded 16A-rated mains IEC cable
and it is important that the amplifier is
earthed at all times via this cable, or an
appropriate alternative. Failure to do
this could be hazardous in the unlikely
event of a fault.
The supplied region-specific 16A mains
IEC cable can be substituted for an
alternative power cable, however,
please make sure that it has an earth.
If any cable becomes damaged you
must discontinue use and replace
it immediately to avoid the risk of
electrocution.
ULTIMA 2 must be permanently
connected to a source of power. The
included mains lead simply plugs into
the ULTIMA 2 IEC mains socket. If the
mains lead is prematurely disconnected
With a thick, solid aluminium chassis,
the ULTIMA 2’s casework largely
protects the sensitive internal circuitry
from radio frequency interference.
However, for optimal performance, it is
recommended that the following points
are observed:
1. Consider placing the
ULTIMA 2 away from
wireless routers.
2. Separate the ULTIMA 2
from amplifiers using
toroidal transformers.
3. Operate mobile phones
at a distance to avoid
interference.
Although the ULTIMA 2
is largely shielded, it can
generate radio frequency
interference that may have an e
ff
ect
on radio and television reception. If
this occurs, please reconsider your
placement.
ULTIMA 2 may still hold charge for up
to 15 minutes.
WARNING:
Never
disconnect the
power cable during
operation. Only disconnect
when ULTIMA 2 is o
ff
. If the
power cable is disconnected
during operation there is a
risk of damage to connected
equipment.
