V2.0W1 WRIST PULSE OXIMETER
11
Picture 2
2. Inserting and Replacing the Batteries
(1). Slide the battery cover in the direction of the arrow by your thumb, and lift the end of the
cover upwards.
Note:
Do not pull too hard on the cover.
(2). Insert one battery as indicated in Picture 2.
Note:
Make sure
that
the polarity of the battery is
correct.
(3). Remove the old battery and discard or recycle
them according to local applicable regulations.
(4). Carefully re-position the battery cover. Do not
force the cover into place; it fits only when positioned properly.
(5). If the wrist oximeter dose not turn on when you press the power on button, reinsert the
battery or refer to “Troubleshooting”
Note:
z
The battery indicator will begin to appear when the voltage is too low, please replace the
battery in time.
z
The Wrist Oximeter contains non-volatile memory, so removing or replacing batteries will
not affect the data will remain in memory until overwritten by newer data stored in Wrist
Oximeter memory. Stored data will remain in memory until overwritten by newer data or
cleared from memory with MedView software.
