6
Notes
-
If the unit is unplugged or loses power, please wait approximately 3 to 5 minutes before restarting the unit. If there is any
attempt to restart before this time delay, the refrigerator will not commence operation.
-
Large quantities of food stored in the appliance or directly in front of the air vent will hinder the cooling efficiency of the
appliance as this can affect the airflow.
-
If you choose to change the thermostat settings in the fridge compartment, adjust the thermostat control by one increment
at a time.
-
Allow 24 hours for temperature to stabilize between adjustments. Do not keep opening and closing the door once
increasing the temperature.
Please note different sections of refrigerator compartment may be warmer or cooler than others – typically
the back wall and bottom lowest shelf will be the coolest, the top door rack will be the warmest. To avoid
frost bite, please don’t put raw vegetables too close to the coolest area.
GENERAL CARE AND MAINTENANCE
Cleaning the Refrigerator
Upon installation of your new appliance, it is recommended that it be cleaned thoroughly and properly maintained thereafter.
Turn off the refrigerator and then unplug the unit from the wall outlet.
Remove all food content before washing the inside with a damp cloth soaked in lukewarm water and baking soda solution. The
solution should be about 2 tablespoons of baking soda to a litre of water.
Be sure to keep the door gasket (seal) clean to keep the unit running efficiently as improper cleaning can cause the seal to
dislodge and tear.
The exterior of the refrigerator should be cleaned with mild detergent and warm water. (door and side of the units only.
Dry the interior and exterior with a soft cloth.
The condenser coils should be vacuumed when they are dusty or dirty. The condenser is an internal tube, non-serviceable.
Don’t need to remove the water tray above compressor to empty water that will be evaporated by heat from compressor.
Vacation Time
Turn off the refrigerator first and then unplug the unit from the wall outlet.
Remove all food.
Clean the refrigerator.
Leave the lid open slightly to avoid possible formation of condensation, mold, or odors.
Use extreme caution in the case of children. The unit should not be accessible to child’s play.
Short vacations:
Leave the refrigerator operating during vacations of less than three weeks.
Long vacations:
If the appliance will not be used for several months, remove all food and unplug the power cord. Clean and
dry the interior thoroughly. To prevent odour and mold growth, leave the door open slightly: blocking it open if necessary or
have the door removed.
Repositioning and Relocating the Refrigerator
Turn off the refrigerator first and then unplug the unit from the wall outlet.
Remove all the food and drinks.
Securely tape down all loose items inside your refrigerator.
Tape the doors shut.
Be sure the refrigerator stays in the upright position during transportation.
Save energy
-
Install the refrigerator in the coolest part of the room, out of direct sunlight and away from heating ducts or registers. Do
not place the refrigerator next to heat-producing appliances such as a range, oven or dishwasher.
-
The refrigerator door should remain open only as long as necessary; do not place hot food inside the refrigerator.
-
Organize the refrigerator to reduce door openings .Remove as many items as needed at one time and close the door as
soon as possible.
-
The refrigerator door should be properly closed to avoid increased energy consumption, and the formation of excess ice
and / or condensation inside.
-
Constantly circulating cold air keeps the temperature homogenous inside the refrigerator. For this reason, it is important
to properly distribute the food, to facilitate the flow of air.
