16
Step 1:
Remove the 5-point safety harness (shoulder straps and pads, crotch belt with central buckle
and pad) - fig. 1 and 2.
Step 2:
Unfold the support leg until it is in place (3).
ATTENTION!
DO NOT PULL THE LOWER PART OF THE SUPPORT LEG! ALWAYS MAINTAIN THE
SUPPORT LEG AS SHORT AS POSSIBLE!
Place the car seat in a position facing
“FORWARD”
. Press the ISOFIX connectors release buttons (4)
and move the connectors forward (5). ISOFIX indicators will show
red
color.
Step 3:
Install the ISOFIX connectors to the ISOFIX guides until you hear a click (6 and 7).
ISOFIX indicators must show
green
color. At the same time, you must press the car seat in a way that
it is closest to the vehicle seat backrest.
Step 4:
Shake the car seat to check if it is well fixed (8). If car seat moves during shaking and the
ISOFIX connectors come out, repeat the actions from step 3, in order to install the car seat again.
Step 5:
Place the child in the car seat. If necessary, adjust the headrest height. Thread the diagonal
belt through the guide under the headrest, as shown in figure 9 and the lap belt through the guides on
both sides of seat.
Step 6:
Insert the diagonal and lap belts in the buckle until you hear a click (10). Make sure the belt is
fixed by trying the pull it out of the buckle.
Step 7:
Make sure that the belts are not twisted and are well attached.
On figures 11, 12 and 13 you can see the anchor point and the position of vehicle belt buckle.
click
Diagonal belt
Diagonal
belt
lap belt
lap belt
