Chipolino FERRARA, Instruction Manual

Page: 10 / 14

fig. 27 fig. 28 fig. 29
fig. 30 fig. 31 fig. 32
9
CONVERTING THE SEAT INTO CARRY COT
FOLDING THE STROLLER
Unbuckle the harness belts. Pull the belts through the corresponding slots of the seat,
backrest and the fabric slots and remove them. Set the seat to the fully reclined position
( fig. 27) . Lift with a hand the two levers on the mechanism for converting the seat into carry cot,
as shown in
fig.28
. Set in a horizontal position the footrest by pressing both buttons at either
end of the footrest (fig.29) . The carry cot is ready for use.
WARNING! Do not place in the carry cot additional mattress thicker than 20 mm! The carry
cot is suitable for babies and little children, who cannot sit unaided, roll over and cannot push
themselves on their hands and knees, when the carry cot is used the harness should be
removed and not keep inside.
When the child can sit unaided, you should use the seat; mount the harness in the reverse
sequence of the described above.
To fold the stroller, perform the following activities:
- Fold the canopy
- Adjust the seat in upright position
- Press the locking mechanism on the left side of the handle bar (fig.30-1)
- Press the button at the center of the handle bar (fig.30-2)
- Press the lever down to direction of the frame (fig.30-3)
- Press down the handle (fig.31) , the stroller will automatically lock (fig.32) and the locking
mechanism will engage.