MCDV2HD 1080P Motorcycle DVR 7
To start your setup:
From the Video Recording Mode, press and hold the “MENU/OK” button to
enter the first part of the SETUP interface. You will see the main menu. To
select specific parameters, press the “UP” or “DOWN” buttons, then press
“OK” to confirm. Press and hold “MENU/OK” to Exit.
Please Note
The DVR has been pre-configured to suit most users but it is
highly recommended to take a few minutes to become familiar with changing
to a different mode, selecting a parameter, setting it and confirming OK.
These are the steps that you will repeat for each of the parameters.
As long as the device is working properly, you only have to set these
parameters once. It is easier to do this setup on the bench, than with the
device installed under the motorcycle seat.
SETTINGS - SETUP
1.
Size
The resolution is fixed at 1080P
2.
Time Stamp
Off
Video file will not display either date or time
Date Only
Video file will only display the date
Date and Time
Video file will display both the date & time - DEFAULT
3.
Loop Recording
The length of the standard video files can be set to one of the following:
1 Minute - 3 Minutes - 5 Minutes DEFAULT is 3 Minutes
4.
Pre-Record
In the
Pre-Record
mode the DVR will start but NOT record to the SD card
until the wired, handlebar controller button is pressed. It will blink rapidly
and you will know it is recoding.
5.
To record Sound
On or Off . The sound is recorded from the DVR unit only. DEFAULT is ON